On/Off Button - Bestway SALUSPA MIAMI AIRJET Manuel De L'utilisateur

NOTE: If the heating system is activated the filtration system will
automatically start.
NOTE: After turning off the heating system the filtration system will
continue to operate.
NOTE: If the spa heater is on when the water temperature is below
42.8°F(6ºC), the heating system will warm the water until 50°F(10ºC)
automatically.
D. MASSAGE SYSTEM BUTTON: Use this button to activate the
massage system, which has a 30-minute auto-shutoff feature. The light
above the Massage System Button displays red when activated.
IMPORTANT: Do not run the Massage system when the cover is
attached. Air can accumulate inside the spa and cause irreparable
damage to the cover and bodily harm.
NOTE: Heat and massage system work together to create a warm
massage experience.
E/G. TEMPERATURE ADJUSTMENT BUTTONS: Pressing the
Temperature Increase or Decrease buttons will cause the LED to flash.
When it is flashing you can adjust to the desired temperature setting. If
you hold these buttons down the values will rapidly increase or decrease.
The new and desired temperature setting will remain on the LED display
for 3 seconds to confirm the new value.
NOTE: The default temperature is 95°F(35°C).
NOTE: Temperature adjustment ranges from 68°F(20°C) to 104°F(40°C).
F. ON/OFF BUTTON: Press this button for 2 seconds to active the control
panel buttons and the light turns to green. Press this button for 2 seconds
to turn off all currently activated functions.
H. CELSIUS/FAHRENHEIT TOGGLE: The temperature can be displayed
in either Fahrenheit or Celsius.
I. WATER FILTER BUTTON: This button turns the filter pump on and off.
The light above the Water Filter Button displays red when activated.
POWER-SAVING TIMER LED:
This flashing LED means you are setting the heating duration. The light will
be on when the heating function starts to work.
This flashing LED means you are setting the number of hours FROM NOW
when the heater will activate. When the light is on, the Power-Saving
Timer function is set.
NOTE: The WATER HEATER rate may change in the conditions below:
• When the outdoor temperature is below 59°F(15°C).
• If the cover is not in position when the heating function is activated.
NOTE: To display the current water temperature, run the filter system for at least a
minute.
The water temperature as tested by an external thermometer may vary from the
temperature as displayed on the spa panel by as much as approximately 35.6°F(2°C).
20