Christopeit Sport CX 6 VR Notice De Montage Et D'utilisation page 20

Step 4:
Installation of the small handle bar (43) with small handlebar bracket (44)
on handlebar post (15).
1. Place the small handlebar bracket (44) on the small handle bar (43) in
such a manner that the bores in the bracket and those at the end of
the handlebar are aligned.
2. Place the whole assembly against the upper end of the handlebar post
(15) through the thread bolts and tighten it with washer (45) spring
washer (32) and self lock nut (46) firmly.
(Note: The handle bar must be aligned so that it is inclined away from
the handlebar post (15).)
3. Put into the each end of small handlebar (43) one end cap (47).
Step 5:
Installation of the right and left pedal tube (21+24) with swivel tube (26)
on the left and right handle bar (18+20) and cross frames (22+104).
1. Push the end of the right pedal tube (24) onto the cross frame (22) and
tighten it with screw (23), washer (16) and spring washer (6) at the cross
frame (22) firmly.
2. Push the swivel tube (26) into the right handle bar (20) and tighten it
with screws (12), spring washer (6) and washer (27) firmly.
3. Install the left pedal tube (21) with all additionally required parts on the
left hand side of the machine as described in 1. + 2.
Step 6:
Installation of the front and rear pedal cover (35, 36+39) on the pedal
tubes (21+24).
1. Push the rear pedal tube cover (39) onto the connection point of cross
frame (22+104) and pedal tube (21+24) and fasten it with screw (37).
2. Put each one of left and right pedal front cover (35+36) onto one con-
nection point of swivel tube (26) and pedal tubes (21+24) together and
fasten them with screws (37+38).
All manuals and user guides at all-guides.com
20