After Use - Meister MAS16xM Traduction Du Manuel D'utilisation Original

5451240-Akkubohrsc_man 27.02.15 10:31 Seite 101
CAUTION! The direction of rotation may only be
changed when the motor is at a standstill!
• Installing screws: Set the right/left switch (6) to right rotation.
• Removing screws: Set the right/left switch (6) to left rotation.
• Safety position: Centre switch position; with the sliding switch in this position,
the machine cannot be operated. Use, for example, when taking a break or
changing bits or drills.
CAUTION! Risk of over winding caused by screwing
screws in too deep. Watch the screwing process
carefully and, if necessary, stop early and finish the
process with an ordinary screwdriver. Carry out test
installations!
Gear switch (Figure 8)
Using the gear switch (3) you may select two different revolution ranges.
• Switch position 1:
• Switch position 2:
The revolution range to be selected is determined by the relevant material and
the intended task and should be tested using a test piece.
CAUTION! Only switch over when the motor is at a
standstill.
11 – After use
• Release the On/Off switch to switch the machine off.
• Set the left/right rotation to the middle position to block the On/Off switch
and prevent unintentional activation of the machine.
All manuals and user guides at all-guides.com
-1
0 – 400 min for installing and removing screws
-1
0 – 1300 min for installing screws and drilling
101