Meister MAS16xM Traduction Du Manuel D'utilisation Original page 99

5451240-Akkubohrsc_man 27.02.15 10:31 Seite 99
Tensioning a tool
Traditional screwdriver bits, bit holder and drills up to a diameter of 10 mm can
be used in the chuck (1) (Figure 5). Only use a tool that can be clamped
securely in the chuck and which is designed for use with this machine. See
"Technical data".
The machine has a quick-action chuck (1). This allows you to
change accessories by hand quickly and without a chuck key (Figure 5).
• Open the claws of the quick-action chuck. To do this, rotate the quick-action
chuck anti-clockwise. Open the quick-action chuck far enough to be able to
insert the tool (Figure 5).
• Insert the tool in the quick-action chuck.
• Rotate the quick-action chuck clockwise and tighten securely.
CAUTION! Accidentally switching the machine on is
an injury risk. Set the switch for the rotation
direction to the middle setting when the machine is
at a standstill in order to activate the lock for the On/Off
switch.
CAUTION! Risk of cuts.
• Wear gloves to insert a drill into the quick-action
chuck.
• Tighten the quick-action chuck to clamp the tool in
place.
The chuck of right/left rotating machines is always
fixed with a left-threaded screw. This must be
loosened from the front through the chuck (1)
before changing it. Left-threaded screws can only be
loosened by turning to the right.
All manuals and user guides at all-guides.com
99