Meister MAS16xM Traduction Du Manuel D'utilisation Original page 98

5451240-Akkubohrsc_man 27.02.15 10:31 Seite 98
3. The charging process should take about 60 minutes. It is finished as soon as
the red LED goes out and the green LED lights up.
4. Press the unlocking button (8) on the rechargeable battery and remove the
rechargeable battery from the charger.
CAUTION! The rechargeable battery is to be
removed from the charger after the charging time is
complete. A constant warming of the charger and
the battery is normal and is not a fault.
TIP! It is recommended to monitor the recharging
process using an electrical time switch!
Checking the charge status of the rechargeable battery
(Figure 4)
To check the charge status of the rechargeable battery, press the test button
(5) (Figure 1). The battery capacity display (4) lights up to show the charging
status as follows:
• Green/Yellow/Red:
• Yellow/Red:
• Red:
9 – Operation
Torque pre-selection
The cordless drill/screwdriver has a torque setting function with 21+1 levels
which helps to avoid damage to the screw or drill head. By rotating the torque
setting (2) (Figure 1) on your cordless drill/screwdriver, you can select the
required level, from 1 (easy screwdriver action) through to maximum (heavy-
duty screwdriver/drilling action). Always select the most appropriate torque for
the job in hand. Do not use the drill setting for screwdriver work.
98
All manuals and user guides at all-guides.com
The rechargeable battery is fully charged.
The rechargeable battery is partially discharged.
The rechargeable battery must be charged.