Thomas VAPORO TROLLEY Mode D'emploi page 12

To work with the steam cleaner
Press the steam cleaner button and direct the steam
towards the surface to be cleaned. Clean off the dirt by
directing the set of steam backwards and forwards over
the surface. Steam will escape from the nozzle once you
release the steam button. You can wipe off the dirt with a
clean cloth or sponge. Surfaces of certain materials can
be very hot. Careful!
Never direct the steam to any one point for too long.
Always try out the steam cleaner first on a not obvious
point!
Always use the cleaning cloth to clean wood and
linoleum flooring. The steam cleaner is not suitable for
cleaning non-sealed wood floors or soft plastic and
wood furniture.
Never use the appliance on cold glass since the hot
steam can crack the glass.
One tank full will last about 25 minutes.
To refill the water tank
Should no steam be discharged but the appliance
is switched on, this means that then the water tank is
empty. The red control lamp will come on in this case.
Immediately switch off the appliance by means of the
on/off switch and disconnect the mains plug. Allow the
appliance to cool down for at least 5 minutes before
refilling with water. Only unscrew the safety valve after
the appliance has cooled down.
The water in the tank is always still hot even after the
appliance has cooled down even for 5 minutes. Care-
fully unscrew the steam safety valve because hot steam
can still be discharged.
The safety valve should never be opened while the
appliance is in use (tank is under pressure).
After steam cleaning
Switch off the appliance once you have finished clean-
ing. Disconnect the mains plug and allow the appliance
to completely cool down (for approx. 5 minutes).
Store the steam cleaner in a dry cool place
12
All manuals and user guides at all-guides.com
To put the steam iron into operation
(special accessory)
The steam iron comprises:
12: Iron sole with double chamber
13: Steam button
14: Cork handle
15: Steam hose with connection plug
16: Control lamp
17: Temperature controller
1.: Insert the plug connector in the steam hose (15) and
2.: Lock the other nose in the plug opening to prevent the
3.: Insert the mains plug in the mains plug box.
4.: Switch on the iron by means of the on/off switch (4)
5.: Set the ironing temperature as required on the thermo-
steam on the thermostat (17) to mark the minimum tem-
perature required. If you go by this setting wait until the
control lamp (16) goes out after which your steam iron
will be ready for use. Set the required amount of steam
by means of the steam volume controller (6) on the
steam cleaner.
Warning: Never leave the hot steam iron unattended!
Risk of fire!
15
16
17
steam generator
in the appliance plug box (11). Make sure that the
plug is plugged the right way round in the appliance
plug box.
plug from sliding out.
on the steam cleaner and wait until the steam control
lamp (5) comes on.
stat (17).
IMPORTANT! You require a minimum tempera-
ture for the steam iron. There is a symbol for
14
13
12