Resetting To The Factory Settings; With The "Reset" Button On The Device - Conrad 98 91 96 Notice D'emploi

e) Use of WPS
• Proceed as follows to use the WPS function.
• If the router is not in operation, activate it fi rst and then wait for approx. 1 minute until the
starting process has been completed.
• Then push the button "WPS" at the back of the device for about 3 seconds and release it
again. The WPS-LED at the device starts to fl ash.
• The router is now in WPS reception mode. To connect a device to the router, push the WPS
button at the respective device as well.
Observe the operating instruction of the device that you want to connect to the router as well.
• Wait until the connection has been established.

13. Resetting to the factory settings

a) With the "Reset" Button on the Device
• To reset the router to the factory settings without web interface, connect it to the plug-in mains
adapter and plug it into a mains socket. Wait for approx. 1 minute until start-up has been
completed.
• Then push the recessed button "Reset" at the device for about 5 to 10 seconds and release
it again. Whether or not the reset was accepted by be seen by all LEDs except for the Power
LED going out for a certain time after a few seconds.
• The device now restarts. This will table take about 1 minutes. Then it is reset to factory set-
tings.
All manuals and user guides at all-guides.com
61