Conrad 98 91 96 Notice D'emploi page 53

• The device now restarts and confi guration is assumed.
Please note:
If the IP-address has changed, you need to log on to the web interface again after
the restart. For this, enter the changed IP address into the address line of the
browser. It may also be necessary to disconnect your PC from the network briefl y
fi rst to have a new IP address assigned to it. You may also restart your PC.
Also observe chapter 12 a) on how to change the IP address.
• If desired, you may also change other settings now. Also observe chapter 12 of these operat-
ing instructions on this.
• To take the device into operation as an access point, connect the LAN port to a free LAN port
of your router with a 1:1-linked network cable. It doesn't matter if you use "LAN1", "LAN2" or
the connection "WAN" of the device, since the three ports and the WLAN interface are con-
nected. Finally, restart the AP by disconnecting it from the power supply briefl y.
The site of setup is generally only limited by the length of the network cable. The max. permis-
sible cable length at 10/100 MBit networks is about. 100 m.
• Confi guration is now complete.
Please note:
Proceed as follows if you have not put the IP-address in the DHCP-area of your
router and later want to change the confi guration. Disconnect the connection cable
from your router. Then restart the access point or disconnect it from the power
supply briefl y. Connect your PC directly to the access point and restart it. Then you
can access the web interface as in the basic confi guration.
All manuals and user guides at all-guides.com
53