Conrad 98 91 96 Notice D'emploi page 42

7. Commissioning
• Unpack the device and accessories fi rst.
• Next, install the two aerials to the corresponding aerial sockets of the device.
• The confi guration should be performed via the LAN interface of the router at all times. There-
fore, connect the "LAN1" connection of the router with a 1:1-connected network cable with a
free network connection of your computer. We recommend that you use the cable from the
delivery scope.
• If you want to confi gure the device as a router for UMTS, insert your activated SIM card into
the SIM card slot.
It is located at the back of the device. For this, observe the fi gure in chapter 6. b).
The card is inserted into the slot with the contacts up and the slanted side to the
right until it latches.
To remove it, push the card and pull it from the slot.
• If you want to confi gure the device as a router for DSL or cable, connect your DSL or cable
modem to the "WAN" connection of the router again. Use a 1:1-connected network cable or
the original cable of the modem.
Switch on the modem.
• Nothing but performing the confi guration is required for the operating modes "Bridge" and
"Wireless ISP".
• Connect the plug-in mains adapter to the intended socket "DC PWR" and connect it to a
mains outlet.
• If you have not done so yet, start your PC and wait until your operating system has booted
completely.
42
All manuals and user guides at all-guides.com