Weidmüller WAVEANALOG PRO Bridge Serie Notice D'utilisation page 12

4288820000_IS_PRO_Bridge.qxd:428882_IS_PRO_Bridge.qxd
1. General instructions
Warning! The analogue signal isolators of the WAVE
be installed by qualified personnel. Be sure not to connect the
unit to power supply before appropriate installation. Do not
select ranges during operation, because live parts are exposed
during this process. Only use a screwdriver which is properly
insulated against the voltage applied to the input when fine
adjusting the potentiometers on the front.
Be sure to observe the national regulations for installation and
selection of cables.
Appropriate safety measures against electrostatic discharge
(ESD) should be taken during assembly and adjustment work on
the WAVE
2. Application
Analogue signal isolators are used for galvanic isolation and conversion of
voltage signals. Input and output signals can be calibrated/switched via
DIP switches. It is not necessary to adjust the pre-settable measurement
ranges. The output signal is linear to the measured voltage.
The supply voltage to the bridge can be set between 4.8 V...10.2 V;
in addition, the offset can also be set.
10
PRO.
ANALOG
PRO may only
ANALOG
07.07