Prepare The Wall; Connecting Power Supply; Install The Rangehood - Faber MIRROR Instructions D'installation

PREPARE THE WALL

1. Disconnect and move freestanding range from cabinet
opening to provide easier access to rear wall. Put a thick,
protective covering over cooktop, set-in range or countertop to
protect from damage or dirt.
2. Determine and clearly mark with a pencil the center line on the
wall where the rangehood will be installed.
3. Draw a horizontal line at 38 5/16" above the cooktop (as indicated
in FIGURE 4). Mark two points (1) (in FIGURE 4) on the horizontal
line, 11 1/2" away from the center line on each side. Make sure
both marks are level.
4. Mark two points (2) (in FIGURE 4) which are 18 9/16" above the
cooktop, and are 7 7/8" on either side of the center line. Make sure
both marks are level. Drill holes in marks 1, 2 and 3
WARNING: THE SCREWS PROVIDED FOR MOUNTING THIS
RANGEHOOD MUST BE INSERTED INTO SOLID WOOD. THESE
MUST NOT BE INSERTED INTO SHEET ROCK.
B
F
F
FIGURE 4

INSTALL THE RANGEHOOD

1. Adjust the two screws on the mounting hardware (B in FIGURE 5)
to the lowest point
2. Hang the hood onto the mounting brackets
3. Connect the hood to the power supply (SEE CONNECTING POWER
SUPPLY ON RIGHT SIDE OF THIS PAGE)
4. Open the upper panel by pressing the L button (see Control Panel
on page 8). Using two hands, remove the grease filters one at a time
by pushing the filter forward and and pulling the handle down.
(FIGURE 6)
5. From the inside of the hood, adjust the mounting screws to make
the hood level (B in FIGURE 5). Install safety screws (11 IN FIGURE
5) and reinstall the grease filters and close the upper panel
6. Turn off the power supply to the hood until finished with the
installation.
7. For ducted installations, the DAMPER (I in FIGURE 1) must be
attached to the exhaust opening at the top of the CANOPY SECTION.
Connect the ductwork and seal all connections with duct tape.
FIGURE 5
FIGURE 6

CONNECTING POWER SUPPLY

Make a hole in the knock out hole on the back of the Mirror
(located 19" from the bottom of the hood, and 4 1/2" in from
the left side)
The Mirror comes with a 3 prong grounded plug out of the top
of the hood. Remove the strain relief on top of the hood and pull
the power plug inside of the hood. Using the knock out hole on
the back of the hood, feed the house power supply cable thru
the wall and into the hood thru the knock out hole. Have an
electrician install a small outlet box and outlet inside the hood
connected to the house power supply cable. Plug the Mirror
power cord into the new outlet box.
If the rangehood does not operate, check that the circuit
breaker is not tripped or the house fuse blown. If the unit still
does not operate, disconnect the power supply and check
that the wiring connections have been made properly.
Version 09/12 - Page 6