Faber MIRROR Instructions D'installation page 7

DUCTED INSTALLATIONS
1. For rear ducted installations, attach the rear chimney
transition to the top of the rangehood (FIGURE 7) with the
4 screws provided.
2. If installing the hood with ductwork venting up thru the
ceiling (not to the rear of the hood thru the wall ) , then the
optional chimney covers (purchased separately) can be
attached over the ductwork. Please call 508-358-5353 for
instructions on attaching chimney covers.
FIGURE 7
DUCTLESS INSTALLATIONS
1. Screw the ductless grille to the top duct with 4 screws
(part C using the E screws in FIGURE 8).
2. Attach the grille cover (H in FIGURE 8) using the cover
screws (I in FIGURE 8).
3. Attach one charcoal filter to each end of the blower. Each
charcoal filter attaches to the grid on the side of the blower.
Rotate the filter clockwise to install and counterclockwise to
remove (as indicated in FIGURE 9).
C
FIGURE 8
FIGURE 9
I
H
E
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the
kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently
in hot detergent solution or washed in the dishwasher. Use
glass cleaner to clean the glass front of the hood and stainless
steel cleaner on the stainless surfaces of the hood. Do not
use abrasive substances.
Version 09/12 - Page 7