A
B
The hood can be operated from the control panel located in the center of the hood , FIGURE 10 is a picture of the
control panel, With LED display in the center
Function
Key
Door closed: press and hold for 2 seconds to open door and
A
turn motor onto last used speed. Door open: quick press to
turn motor on and off
Decreases the vent speed.
B
Increases the vent speed.
C
By pressing this key the intensive boost function is activated
D
from any previously selected speed. The intensive boost can
be activated even when the motor is OFF. After ten minutes of
intensive power, the hood switches back to the last selected
speed. This function is recommended for cooking conditions
where vapors and odors need to be eliminated immediately and
quickly. Can only be operated with door open.
By pressing this key the
E
the hood on at 60 CFM for 10 minutes every hour with a noise
level of just .5 sones. This setting can operate all day and
night to refresh and clean your home. After 10 minutes
every hour, the motor switches off automatically. Press the
button again to turn off the 24 hour function. Can only be
operated with door open.
By pressing this key the 30 minute delay shutdown mode is
F
activated which is used to eliminate any residual odor in the
kitchen for 30 minutes. After 30 minutes the hood and lights
turn off automatically. It can be turned on at any speed, and it
is turned off by pressing the key again.
By pressing this key, the grease filter and charcoal filter
G
saturation alarms are reset when held for 3 seconds, see
page 9 for more information
Changes the level of lighting, can adjust the lights to 5 different
H
levels of intensity
Door closed: press and hold the light button for 2 seconds,
I
and the door opens and lights turn at maximum level, use
button H to adjust level of lights
Door open: quick press to turn on and off lights
Door closed: press and hold the hinge button for 2 seconds
L
to open the door, turns the hood on speed 3 and turns the
lights on
Door open: when pressed for 2 seconds, turns off the motor,
lights and closes the door
Attention: To completely close the upper panel, the user must hold down the (A, I or J) buttons until the door is
completely closed. If removed before completely closing or if an object is in the way, the panel stops. Simply
open the panel again with A, I, or J buttons and repeat closure process.
USE AND CARE CONTINUED - CONTROL PANEL
C
D
E
24 hr - function
is set which turns
F
G
LED Display Indicators
The current speed is shown in the center when the
hood is turned on. Indicated by the number of speed
bars low to high
The number of speed bars decrease
The number of speed bars increase
The i symbol flashes and all the speed bars light
up
24 symbol is lit and speed bars light up and turn off
in a row
clock symbol flashes and speed bars indicating
current speed are lit
After 100 hours of operation the droplet symbol is lit,
indicating saturation of the grease filters
After 200 hours of operation, the letter C is lit to
indicate saturation of the charcoal filters
FIGURE 10
H
I
J
Version 09/12 - Page 8