Hybrid'' Mode; Connecting Passive 12Xt And Sb118 To La4; [12Xtp_Sb118] Preset - L-Acoustics 12XT Manuel D'utilisation
Masquer les pouces
Voir aussi pour 12XT:
- Manuel d'utilisation (51 pages) ,
- Manuel utilisateur (3 pages) ,
- Mode d'emploi (61 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Table 3: Accessible controls in ''HIGH-PASS'' mode for PASSIVE 12XT
LA4 Inputs/Outputs
Elements to connect
IN A
IN B
OUT 1
OUT 2
OUT 3
OUT 4
*
IN: input signal.
A: channel A.
Note: The complimentary SB118 subwoofers must be connected to additional LA4 or LA8 amplified controllers. Please
refer to the ''SB118 - User Manual''.
7.2.3
"HYBRID'' mode
In the ''HYBRID'' mode the PASSIVE 12XT and SB118 enclosures are connected to the same LA4 amplified controller
thus limiting the number of required units. The bandwidth of the system is extended down to 32 Hz. The
recommended ratio is one PASSIVE 12XT for one SB118.
7.2.3.1
The PASSIVE 12XT and SB118 enclosures connect to the LA4 outputs as follows: channels 1 and 3 are dedicated to
both SB118 enclosures, channels 2 and 4 are dedicated to both PASSIVE 12XT. Therefore, a single LA4 amplified
controller can drive up to two PASSIVE 12XT and two SB118 enclosures (Figure 8).
!
A maximum of one SB118 enclosure can be connected per LA4 output channel 1 or 3.
IMPORTANT
Note: The system resources are optimized for two PASSIVE 12XT and two SB118 per LA4.
12XT_UM_ML_1.2
All manuals and user guides at all-guides.com
Preset
assignments*
Input signal A
IN_A
Input signal B
IN_B
PASSIVE 12XT
PA_A
PASSIVE 12XT
PA_A
PASSIVE 12XT
PA_B
PASSIVE 12XT
PA_B
B: channel B.
PA: passive enclosure.
Connecting PASSIVE 12XT and SB118 to LA4
w w w . l - a c o u s t i c s . c o m
Accessible (O) and blocked (X) controls
Mute
Gain
Delay
X
O
O
X
O
O
O
O
O
O
O
O
O
O
O
O
O
O
Polarity
O
O
EN
O
O
O
O
15 en
Publicité
Chapitres
Table des Matières
