Quick Start - NEC MultiSync FP1355 Manuel Utilisateur

Masquer les pouces Voir aussi pour MultiSync FP1355:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 71
All manuals and user guides at all-guides.com

Quick Start

To attach the MultiSync FP1355 monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more
information, refer to the display card manual.
3. For the PC or Mac with DVI Analog output: Connect the DVI end of
the VGA to DVI-A signal cable to the connector of the display card in
your system (Figure A.1). Tighten all screws.
For the PC with VGA Analog output: Connect the VGA end of the
VGA to DVI-A signal cable to the connector of the display card in your
system (Figure A.2).
For the Mac: Connect the MultiSync Macintosh cable adapter (not
included) to the computer (Figure B.1). Attach the VGA end of the
VGA to DVI-A signal cable to the Macintosh cable adapter
(Figure B.1).
NOTE:
Some Macintosh systems do not require a Macintosh
cable adapter.
Figure A.1
01b_english
English-2
2
Figure A.2
22.02.2001, 14:12 Uhr

Publicité

Table des Matières
loading

Table des Matières