Festo MPA Mode D'emploi page 12

2 Multipin connection
2.1 Multipin plug
For controlling the valves, each valve solenoid coil (re
ferred to in the following as coil) is assigned to a certain
pin of the multipin plug. Irrespective of blanking plates or
valve plates fitted, valve locations for controlling:
one coil
two coils
Caution
The components of the valve terminal contain electros
tatically sensitive elements. The components will be
damaged if you touch the contact surfaces of the plug
connectors and if you do not observe the regulations
for handling electrostatically sensitive components.
Long signal cables reduce the immunity to interference.
Do not exceed the maximum permitted signal cable
length of 10 m.
12
==> occupy one address
==> occupy two addresses.
Festo MPA−... 0305a English