Maintenance And Service; Maintenance And Cleaning - Bosch GST Professional 65 Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-290-004.book Page 12 Monday, April 21, 2008 11:30 AM
12 | English
Parallel Guide with Circle Cutter (Accessory)
For cuts using the parallel guide with circle cutter
18 (accessory), the thickness of the material
must not exceed a maximum of 30 mm.
Parallel Cuts (see figure F): Loosen the locking
screw 17 and slide the scale of the parallel guide
through the lead 16 in the base plate. Set the de-
sired cutting width as the scale value on the in-
side edge of the base plate. Tighten the locking
screw 17.
Circular Cuts (see figure G): Set the locking
screw 17 to the other side of the parallel guide.
Slide the scale of the parallel guide through the
lead 16 in the base plate. Drill a hole in the work-
piece centred in the section to be sawn. Insert
the centring tip 19 through the inside opening of
the parallel guide and into the drilled hole. Set
the radius as the scale value on the inside edge
of the base plate. Tighten the locking screw 17.
Coolant/Lubricant
When sawing metal, coolant/lubricant should be
applied alongside cutting line because of the ma-
terial heating up.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean the saw blade holder regularly. For this, re-
move the saw blade from the machine and lightly
tap out the machine on a level surface.
Heavy contamination of the machine can lead to
malfunctions. Therefore, do not saw materials
that produce a lot of dust from below or over-
head.
1 609 929 K81 | (21.4.08)
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be de-
graded. The use of a stationary extraction
system is recommended in such cases as
well as frequently blowing out the ventila-
tion slots and installing a residual current
device (RCD).
Lubricate the guide roller 5 occasionally with a
drop of oil.
Check the guide roller 5 regularly. If worn, it must
be replaced through an authorised Bosch after-
sales service agent.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Bosch Power Tools