Olsberg 14/534 Notice D'utilisation page 25

• Pull the connection cords of the heating elements
completely through the openings prepared and
bow the connection cords at the coloured bushes
carefully.
Caution: Do not push the connection cords
backwards to the interior.
• Fit the upper insulation mats tightly onto the cover
bricks (Fig.7).
Caution: Do not mix up upper insulation during
installation!
Element ratings
You can choose from 3 different power ratings.
Connect the heating elements on to the terminal strip
X2 depending on the power rating chosen according
to the circuit diagram (page 28). The terminal strip is
on the left hand side of the heater on the inside panel.
Cover up the non-applicable power ratings on the
heater rating label (bottom right of heater) with the
label provided (in the bag with the wall-fixing screw) -
see example of rating label on page 29. For this, re-
move the protective paper from the adhesive side of
the label. Position the adhesive side on the power
rating to be covered by means of the frame-outline
printed on the rating label. Press the covering label
firmly and then remove the carrier foil. Proceed in the
same way for the second rating to be covered.
Tip: It is easier to cover the rating if the edges of the
label are cut off beforehand.
Put a cross against the chosen rating in the circuit
diagrams, both in the Instruction Leaflet, and in the
right hand inside panel.
All manuals and user guides at all-guides.com
Inner upper insulation
15x242x455
Fig.7 Upper insulation
Outer upper insulation
10x270x505
25