Using The Memory Function - ProMed BDS-700 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
OPERATING THE DEVICE
Note:
When the device determines during inflating that the pressure is not sufficient, it automatically
starts a new inflating process.
Note:
If the device does not stop inflating, press the Start/Stop button (A) which leads to an
interruption of the measurement and the immediate reduction of the cuff pressure.
Note:
If it is necessary to abort the measurement for whatever reason (e.g. Discomfort), this is
possible by pressing the Start/Stop button (A) at any time. This interrupts the measurement
and immediately reduces the cuff pressure.

Using the memory function

This device has a memory for the storage of 60 measurements. Each time a measurement is
completed, the device automatically stores the blood pressure as well as the pulse frequency.
If 60 data sets have already been stored, the oldest measured values are replaced by the
DE
new ones.
Reading the measured values
• By pressing the Memory button (B) you enter the memory
EN
menu.
• If no measured values are stored, the display only shows date
and time. Otherwise, the display shows the average of the last
measured value.
FR
• By pressing the Memory button (B) again you can read the
individual measured values (the last value is displayed first,
the first value is displayed last).
IT
• When the voice output is activated, the device will announce the stored measurement
results and the classification according to the WHO scale.
• To exit the memory menu, press the Start/Stop button (A).
ES
• When the device is in the memory mode and is not used for more than 2 minutes, it
automatically switches off.
NL
Deleting measured values
• By pressing the Memory button (B) you enter the memory
menu.
RU
• To delete all measured values, hold down the Memory button
(B) for at least 10 seconds. The device confirms the deletion
with a signal tone. To switch off the device, press either the
Start/Stop button (A) or the Memory button (B).
PL
Note:
TR
Deleting measured values cannot be reversed.
AR
32

Publicité

Table des Matières
loading

Table des Matières