ProMed BDS-700 Instructions D'utilisation page 29

OPERATING THE DEVICE
Setting the clock
Upon initial commissioning / battery change
After having inserted new batteries and when the device is switched off, the Promed BDS-700
is always in the time mode.
• To set the time, press the Start/Stop button (A) and the Memory button (B) at the same
time and hold them down for 2 seconds.
• On the display, the month indicator flashes.
• By pressing the Memory button (B) you can set the value (1-12).
• By pressing the Start/Stop button (A) you can switch to the setting of the day; the day
indicator flashes. By pressing the Memory button (B) you can set the value (1-31).
By pressing the Start/Stop button (A) again you can switch to the setting of the hour; the
•
hour indicator flashes. By pressing the Memory button (B) you can set the value (1-24).
• By pressing the Start/Stop button (A) again you can switch to the setting of the minutes;
the minute indicator flashes. By pressing the Memory button (B) you can set the value
(1-60).
• To store the entries, press the Start/Stop button (A) again.
• When you do not press a button for more than 1 minute, the Promed BDS-700
automatically turns off and switches to the time mode. No entries are stored.
Setting the voice output and volume
When the Promed BDS-700 is in the time mode, you can switch to the
language setting mode by pressing the Memory button (B) for a longer time.
Hold the button down until the desired language sounds and is shown on
the display (L1 = German, L2 = English, L3 = Spanish, L4 = Dutch, L5 =
French, L6 = Italian, L7 = Portuguese, L0 = no voice output). By releasing
and pressing the Memory button (B) again the desired language is selected.
If you hold down the Memory button (B), the volume of the voice
announcement can bet set. This is shown by a changing bar display on the
left side of the display. When you have set the desired volume, store it by
releasing the Memory button (B).
29
DE
EN
FR
IT
ES
NL
RU
PL
TR
AR