Kohler K-5401-PA-0 Guide D'installation page 9

38" (965 mm) –
66" (1676 mm)
Docking Station
6. Install the Remote Control - Residential
Determine the desired location of the remote control docking station.
Position the mounting bracket in the desired location and mark the location of the screw holes.
Remove the mounting bracket.
Drill 1/4" holes at each of the screw locations.
Install an anchor into each of the holes.
NOTE: A screw and washer designed to make the docking station tamper resistant are provided.
Installation is optional.
If desired, install the dock bracket (shown in next step) to the docking station with the four screws.
If desired, install the optional tamper resistant washer and screw.
Attach the mounting bracket to the wall using the two screws (provided).
Place the remote control on the docking station.
Install the batteries in the docking station (consult the Homeowners Guide for instructions if
needed).
Attach the docking station to the mounting bracket.
To pair the remote control to the toilet, consult the Homeowners Guide.
Kohler Co.
Screw
36"
(914 mm)
9
Anchor
Mounting Bracket
Docking
Station
Remote Control
1357210-2-C