Kohler K-5401-PA-0 Guide D'installation page 5

2. Prepare the Site
CAUTION: Risk of hazardous gases. If the new toilet is not installed immediately, temporarily
place a rag in the closet flange.
NOTE: If the rough-in distance is less than 12" (305 mm) the seat may strike the wall when it is opened.
Confirm that the rough-in is 12" (305 mm) before installing the toilet.
Remove the old toilet.
Remove the wax residue from the flange.
NOTE: Do not install the wax ring at this time.
Move the toilet into the installation position.
Confirm that the toilet is properly aligned with the floor flange.
Using the toilet as a template, mark the location of the stud holes.
Verify that the supply stop and electrical outlet are located within the supplied dimensions.
Remove the toilet from the temporary position.
Using a 3/16" bit, drill holes at the marked locations.
For tile installations, drill a relief hole in the tile.
Install the electrical outlet at the location shown.
Kohler Co.
5-1/2" (140 mm) Min
8" (203 mm) Max
Supply Stop
Location
3" (76 mm) Min
6" (152 mm) Max
12"
(305 mm)
5
3" (76 mm) Min
6" (152 mm) Max
5" (127 mm) Min
7" (178 mm) Max
Stud Hole
Location
Floor Flange
Location
Centerline
1357210-2-C