Before You Begin (cont.)
IMPORTANT! The water supply input pipe must be a minimum of 1/2" copper pipe or 3/4" PEX tube to
provide the minimum water flow for this product to operate properly.
IMPORTANT! Use the supply hose and valve (1/2" NPT) provided with the product. The previously
installed hose and valve will not work with this product.
IMPORTANT! This product requires a minimum flow rate of 6.0 gal/min (23 l/min) when installed for
satisfactory rim wash performance. Maximum static pressure is 80 psi (552 kPa).
IMPORTANT! For installation in Mexico, the recommended static pressure is 45 psi (310 kPa).
NOTICE: The Canadian Electric Code requires receptacles installed in bathrooms to be located at least
39-3/8" (1000 mm) from a bath or shower if practical, but in no case less than 19-11/16" (500 mm). If the
installation is in Canada, install this unit in accordance with the Canadian Electrical Code, Part 1.
Observe all local plumbing and building codes.
Carefully inspect the new toilet for any damage.
There is a wiring schematic on the inside of the access cover.
Consult the Homeowners Guide for user directions.
Consult the Homeowners Guide for troubleshooting instructions.
Kohler Co.
3
1357210-2-C