Mains Connection; Manual Function - BH FITNESS G2465 Manuel

ELECTRONIC MONITOR

MAINS CONNECTION

Insert the jack (m) for the transformer
into the connection hole (k) on the
main body (bottom, rear of the
machine) and
transformer into a 220 V mains supply.
(Fig 1A Mod.
Mod.H8715).
Note: The transformer
necessary to charge the battery after
long periods of inactivity. Disconnect
the transformer before using the
machine.
To give you greater control over your
exercise, this electronic unit provides
simultaneous read-outs of speed,
distance, exercise
calories burnt and pulse rate.
If at any time during exercise you
press the START/STOP button then
all of the unit's functions will stop.
Pressing the START/STOP button
again will restart the machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 90 seconds.
Important:
components in special containers, Fig. 2.
MONITOR FUNCTIONS
This monitor has 7 keys: RECOVERY,
TOTAL RESET, START / STOP;
RESET, ENTER; UP▲; DOWN▼.
The program level you have selected
is shown simultaneously in the central
section of the display. The windows at
the bottom of the display show the
TIME; RPM/ SPEED; DISTANCE;
WATT/CALORIES; PULSE RATE.
This monitor also has 1 manual program,
then plug
G2465; Fig
is
time,
Deposit electronic
English
12 pre-set exertion level programs; 1
WATT program; 4 Heart Rate Control
programs; 4 user defined programs.
The monitor will switch on displaying
the message U1 in the centre of the
screen. Select the user, between U1-
the
U4, using the ▲/▼keys and then
press the ENTER key.
1B
Next the Male / Female symbols will
appear, Select using the ▼▲ keys and
only
press ENTER to confirm. Then Age will
appear, select using the ▼▲ keys
(between 1 to 99) and press ENTER to
confirm. It will now ask for your height,
select using the ▼▲ keys (between
100 to 200 cm) and press ENTER to
confirm. Weight will appear, select
using the ▼▲ keys (between 20 to 150
kg) and press ENTER to confirm.
watts,
CHANGING
WORK MODE TO ANOTHER
This monitor allows you to work in 4
different modes: Manual, Program,
User and Pulse (TARGET HR). In
order to pass from one mode to
another
button to stop the monitor, then press
RESET and, with the help of the ▲/▼
buttons and ENTER key, select the
desired mode.

MANUAL FUNCTION

After entering your personal data the
LEDs for the various programs will start
flashing the monitor USER, MANUAL,
PROGRAM and HRC.
Press the ▲/▼ keys to select the
MANUAL function and press ENTER.
Press the START / STOP key to start
exercising and use the ▲/▼ keys to
increase or decrease the exertion level.
10
FROM
press the START/STOP
ONE