Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8336174
EXTENSION CORD
1.
Never use an extension cord that doesn't match or exceed the amperage rating of the tool.
Using a cord that is too long or an incorrect gauge could cause the following hazards:
a.
Fire from overheating.
b.
Electric shock from melting or damaging the cord's insulation.
c.
Underpowering the tool causing a functional failure, resulting in personal injury or
damage the tool.
d.
A cord that is too long may create a hazard to others moving within the work area.
2.
Use the tool without an extension cord whenever possible. Only use an extension cord as a
temporary means of reaching the power supply. Also unroll the cord completely to prevent it
from overheating and damaging the electrical insulation.
3.
When operating a power tool outside, use an outdoor extension cord marked 'W-A' or 'W'.
These cords are rated for outdoor use. Constructed of more durable materials, they can
withstand temperature changes, UV light (sunlight) and moisture, reducing the risk
of electric shock.
4.
Use in conjunction with a Ground Fault Circuit Interrupter (GFCI). If operating a power tool
in a damp location is unavoidable, the use of a GFCI reduces the risk of electric shock. It is
recommended that the GFCI should have a rated residual current of 30 mA or less.
LOW VOLTAGE
Low voltage may cause overheating due to higher power current being drawn to the tool that will shorten
the motor life.
An extension cord may cause a drop in power to the tool if it is too long or the amperage rating is not
correct. This may result in the following:
•
The tool will not activate when switched on.
•
The tool may switch on, but fails to maintain power when applied to a workpiece.
•
The tool may overheat, possibly starting a fire.
Test the tool by plugging it directly to the power supply. If it powers on, change the extension cord with
the correct rating and as short as needed. The workpiece may also need to be relocated closer to the
power supply.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
5 in. Angle Grinder
V 2.5
7
Publicité
Table des Matières
