Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 2.5
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever possible.
a.
Use extension cords or surge protectors only when the tool's power cord cannot reach a
power supply from the work area (see below).
2.
Do not operate this tool if the power cord is frayed or damaged as an electric shock may occur,
resulting in personal injury/death or damage the tool.
a.
Inspect the tool's power cord for cracks, fraying or other faults in the insulation or plug
before each use.
b.
Discontinue use if a power cord feels more than comfortably warm while
operating the tool.
c.
Take the following steps if either of the above situations occur:
i.
Tag or mark the tool as 'defective' or 'out of service' until repaired.
ii.
Contact an electrician or qualified person to replace the power cord.
3.
Prevent damage to the power cord by observing the following:
a.
Never use the cord to carry the tool.
b.
Do not pull the plug from an outlet by the cord.
c.
Keep the power cord clear of the tool and the tool's work path while in operation. The cord
should always stay behind the tool.
d.
Keep cord away from heat, oil, sharp edges or moving parts.
e.
Do not allow people, mobile equipment or vehicles to pass over unprotected power cords.
i.
Position power cords away from traffic areas.
ii.
Place cords in reinforced conduits.
iii.
Place planks on either side of the power cord to create a protective trench.
f.
Do not wrap cord around tool as sharp edges may cut insulation or cause cracks if wound
too tight. Gently coil cord and either hang on a hook or fasten with a device to keep cord
together when storing.
6
All manuals and user guides at all-guides.com
5 in. Angle Grinder
For technical questions call: 1-800-665-8685
8336174
Publicité
Table des Matières
