Unit Installation - Phonocar VM 041 Notice De Montage Et D'emploi

Installation and uninstall
Notes of installation
1. Before installation, please make sure properconnections are conducted and the unit operates normally.
Improper connection may result in damage to the unit.
2. Use only accessories designed and manufactured for this unit and other unauthorized accessories may
result in damage to the unit. 3) Before installation, please fasten all power cables. 4) DO NOT install the unit
in the place where close to hot area to prevent damage to electrical components such as the laser head. 5)
Install the unit horizontally. Installing the unit more than 30 degree vertically may result in worse performan-
ce. 6) To prevent electric spark, connect the positive pole first and then the negative pole. 7) DO NOT block
the cooling fan exit to ensure sufficient heating dissipation of this unit, or it may result in damage to this unit.

Unit Installation

Method A
1. Insert mounting bracket into dashboard,choose appropriate mounting tab according to the gap width,
bending the mounting tab outwards with a screwdriver to fix the mounting bracket in place.
2. Use 2 pieces of M5×5 cone shaped screw to fix two assemble bars on both sides of the unit
(see picture 1).
3. Screw in 1 piece of M5×24 to the hole of the unit back and put on a rubber sheath over the screw.
(see picture 2)
4. Inserttheunitintothebracket,fastentheM4×6 screw to thefireproofing board available at theback ofthe
dashboard, and use 4 piecesof M2×2 screw to lock the assemble bars and the mounting bracket in position.
Note: According to the depth of the opening, use different length of assemble bar accordingly. If the opening
is too shallow, the monitor may be extended out 10mm from the dashboard.
57
GB
1