Phonocar VM 041 Notice De Montage Et D'emploi page 52

P.VOL
P.VOL means Programmable Volume.
You can balance the volume among different audio sources using this function.
• Source
Select one playing source that you want to set relative volume.
• Level
You can set relative volume level from -6 to 6.
TS CAL
When the touch function is not sensitive or valid, you should calibrate the touch screen by this function.
Calibrate the touch screen just following the screen introductions after entering the TS CAL mode.
EQ
Audio control allows you to easily adjust the audio system to get the best possible sound effect.
1. Enter the EQ setup mode
Press the [EQ] key on the remote control or touch the EQ icon in the user interface and the following inter-
face will display on the screen .
EQ parameters
2. Select EQ mode
Touch the EQ selection bar repeatedly and the EQ mode will change.
3. Adjust EQ parameters
To adjust EQ parameters, touch and drag the EQ parameters adjustment bar.
4. Adjust Front/Rear/Left/Right fader and balance
You can adjust front/back/left/right balance of the speaker to get larruping listening effect according to the
surroundings and your interest. To adjust Front/Rear/Left/Right fader and balance, touch and drag the small
white point in the Fader/Balance adjustment area.
Notes:
1. The unit has provided some EQ modes: User, Rock, Hip Hop, Dance, Latin, Rave, Urban, Acoustic.
2. Different EQ reflects in different Bass, Treble and Middle level. The parameters of the EQ modes has
been preset and you can not change them besides 'User'.
3. The EQ mode will change to 'User' automatically when you adjust the value of BASS, TREB or MID
under the modes besides 'User'.
4. The value of SUB is independent of EQ mode and can be adjusted solely.
EQ selection
52
Fader/Balance
adjustment area