Etac molift Nova StandUp Manuel D'utilisation page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Never lift a user higher than is necessary to
carry out a sit to stand transfer. Remember
that wheels on a mobile hoist must NOT be
locked during the transfer
Be careful during movement, the user may swing during turns,
stops and starts. Be careful when manouevring close to furniture
and similar to ensure the suspended user does not hit anything.
Avoid deep pile carpets, high thresholds, uneven surfaces or
other obstacles that may block the castors. The hoist may
become unstable if forced over such obstacles increasing the risk
of it tipping over.
Never leave a user unattended while being
hoisted.
The hoist shall not be used to lift or move
users on sloping surfaces
Sitting position - Removing the sling
1. Lower the user into a sitting position. Release the lifting
straps from the suspension. Remove the hoist, and unlock the
waist belt buckle.
2. Stand next to the chair and ask the user to lean forward.
Support the user with one hand if necessary. Pull the sling away
with one hand, and ask the user to lean back in the chair.
Remove the sling gently to ensure the user
does not fall forward.
Recycling
Recycling instructions are available at Etac.com
Troubleshooting
Symptom
Possible Cause/Action
The sling does not
Wrong sling size. Try other size.
fit the user.
The sling is not correctly positioned.
Reposition the sling.
The sling is sliding
The user is not leaning backwards. Make
up to the users
the user lean backwards when lifting.
armpits
The waist belt is loose. Tighten the waist
belt properly.
The user is not able to take load on their
legs/feet. Evaluate whether a sit to stand
hoist is right or if the user requires a pas-
sive hoist.
User is sliding
The lifting straps are not fastened cor-
through/out of
rectly. Make sure both lifting straps are
the sling.
equal in length.
The sling is too big.
Try a different size
The user is not leaning backwards. Make
the user lean backwards when lifting.
The waist belt is loose. Tighten the waist
belt properly.
The user is wearing slippery clothes.
Change or remove some of the clothing.
The user is not able to weight bear on
their legs/feet. Evaluate whether a sit to
stand hoist is right or if the user requires a
passive hoist.
7
Molift EvoSling / www.etac.com

Publicité

Table des Matières
loading

Table des Matières