Breakdowns And Solutions - Lanaform Moya Mode D'emploi

To clean the transducer
01 Put 2 to 5 drops of vinegar on its surface
and leave them there for 2 to 5 minutes.
02 Brush the foam off the surface with a
soft brush or cotton bud. Do not use
a hard tool to scrape the surface.
03 Do not use soap, solvent or spray
cleaner to clean the transducer.
To clean the reservoir and reservoir cover:
01 Use a soft cloth and vinegar if
there are any foam or limes-
cale deposits on the inside.

Breakdowns and solutions

In the event of a malfunction under normal conditions of use, please refer to the following list:
No mist.
Mist has an unusual smell.
6:
If there is no light.
The water level in the
reservoir is too low.
The temperature of
the unit is too low.
The water has been standing
in the reservoir for too long.
02 Rinse them in clean water.
Do not use products containing bleach to
clean the device, but washing up liquid or
vinegar only!
Do not immerse the base
Storage
Having cleaned and dried the device, store it
in a dry, cool place out of the reach of children.
Check that the device
is connected and that
there is no mains fault.
Add water to the reservoir.
Place the unit in a room at
ambient temperature for
half an hour prior to use.
Clean the reservoir and
pour fresh, distilled or dem-
ineralised water into it.
1 in water!
11
/ 84