Choice Of Flue Gas And Air Connection Placement - Wamsler PYLON 1G Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

for the chimney sweep and be properly insulated against condensation. The line
should not be longer than 4 m and not have more than 3 bends. If the line leads out-
doors, it should be provided with a suitable windbreak and fly screen.
General information on the subject of room air dependent or room air inde-
pendent operation:
The stove is supplied as a standard room air-dependent fireplace stove. This means
that the stove draws all of the combustion air from the installation room via the central
air intake on the back. A sufficient supply of combustion air (at full load approx. 25m³ /
h) is absolutely necessary.
In combination with ventilation and air conditioning systems (e.g. controlled ventilation
systems, fume hoods, etc.), Section 4 of the Firing Ordinance (FeuVO) is decisive in
Germany. The flue gas routing must be monitored by special safety devices (e.g. via
an approved differential pressure monitor) or, if a ventilation system is used, this must
ensure that no negative pressures greater than 4 Pa occur in the installation room
compared to the outside and that the necessary combustion air (approx. 25 m3 / h) for
the fireplace.
Please always observe - in consultation with your authorized district chimney sweep -
the applicable local regulations and rules. We cannot accept any liability for changes
made after this manual has been printed. We reserve the right to change without no-
tice.
The above-mentioned safety devices are not a substitute for professional planning
and design of an adequate combustion air supply.
As part of the acceptance, the district chimney sweep must check the adequate com-
bustion air supply / overall installation.

2.6 Choice of flue gas and air connection placement

The following steps must be observed when converting the flue gas connection:
1. Drill out the existing
3mm holes with a 6mm
drill (6x)
2. Drill out the three blind
rivets of the inner sheet
metal with a 6mm drill
and remove them. Be
careful not to let the
tray fall into the oven.
1
2
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pylon 3g18820

Table des Matières