Danby DPAC12010H Guide D'utilisation Et Soins De Propriètaire page 6

FEATURES OF
THE CONTROL
PANEL
KEY PAD FUNCTIONS
POWER SWITCH: Turns unit ON/OFF
MODE: Allows you to scroll through and select
desired operating mode.
FAN: Select from three different fan settings; High,
Medium, and Low.
AUTO-TIMER
AUTO-TIMER Adjust:
Auto off- With machine in running mode, press timer
button to set timer control. Press
select number of hours you would like the unit to run
before it automatically shuts off.
Auto on- With machine in stand by mode, press timer
button to set timer control. Press
select number of hours before the unit automatically
starts running in air conditionning mode.
NOTE: The time is adjustable between 1-24 hours.
TEMPERATURE Adjust:
• Used for adjusting the thermostat.
• The default display is room temperature.
• In cooling mode, when
set temperature is displayed and may be adjusted. After
15 seconds the display will revert back to room
temperature. Temperature is only adjustable in cool mode.
NOTE: By pressing both
same time for more than 3 seconds, the display will
toggle between Celsius and Fahrenheit.
STATUS DISPLAY
Warning Light
Condensed water may accumulate in the unit. If the
internal tank becomes full, the Warning signal in the LCD
Display will light up and the unit will not operate until the
unit has been drained.
NOTE: After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
OPERATION
or buttons to
or buttons to
button is pressed, the
buttons at the
5
Timer & Temp. Display
Room Temp.
Temp. Set
Timer Set
MODE INDICATOR LIGHTS
Cooling Mode
When cool mode is selected, the indicator light
will shine GREEN. During the cooling mode, the
air is cooled and hot air is exhausted outside
through the exhaust tube. Adjust fan speed to suit
your desired comfort level.
Note: The air exchange h ose must vent outside
the room when using cool mode.
Dehumidify Mode
When dehumidify mode is selected, the indicator
light will shine ORANGE. Air is
dehumidified as it passes through the unit,
without being in full cooling mode. The fan will
operate on med. speed. If room temperature is
>25°C (77°F), fan speed can be adjusted;
otherwise fan speed is fixed to "low".
Note: The warm air exchange hose must vent
inside the room when using Dehumidify Mode,
not outside as it does when cooling. If the unit is
vented outside, some cooling will occur.
Fan Mode
When fan mode is selected, the indicator will
shine YELLOW. Air is circulated throughout the
room with no cooling.
Note: The unit does not need to be vented in Fan
mode.
Heating Mode
When heating mode is selected the indicator will
shine RED. Heating is activated only when the
ambient temperature is below 25°C (77°F).
FAN SPEED INDICATOR LIGHTS
High Fan
Medium Fan
Low Fan