Master VARITEMP Mode D'emploi page 5

Typical Applications
4) When the task is completed,
move rocker switch to "Cool"
position. Allow blower to operate
for a few minutes on cool.
Shrinking Tubing
Use stand to free both hands. Slide
tubing over area to be insulated.
Place in air stream and move with
a side to side motion until tubing
has shrunk. Remove from air
stream.
Shrinking Packaging
After shrink wrap has been sealed
around product, poke a small hole
in it to allow trapped air to escape.
Then wave heated air stream back
and forth across package until
shrink wrap has evenly shrunk.
Removing Floor Tile
Direct heated air stream at tile to
be removed in a back and forth
motion. This will soften the adhe-
sive backing. Place putty knife
under tile and lift to remove.
NOTE: Users should independently evaluate the suitability of the product for their application.
www.masterappliance.com
(cont'd)
Bending and Forming Plastics
Experiment with a piece of scrap
material first to develop a proper
technique. Place plastic piece into
a proper holding fixture. Wave hot
air along the whole length of the
"Bend" line until plastic softens
along that area. Bend plastic to
desired position.
Removing Old Putty
When removing putty from a bro-
ken window, carefully remove the
broken glass first. When removing
putty from an undamaged window,
direct the hot air stream away from
the glass to prevent cracking due
to thermal shock. It is convenient to
shield the glass from the hot air
with a large putty knife. Wave the
hot air stream at putty until soft-
ened. Remove with putty knife.
Speed Drying Parts
Parts and other materials can be
speed dried by waving the heated
air stream over the work until dried.
Stretching, Shaping and
Installing Vinyl
Direct hot air stream at vinyl sec-
tion and wave heat gun in a back
and forth motion. Stretch and
shape until wrinkles are removed.
DO NOT aim at glass.
Defrosting Frozen Coils or Pipes
Direct hot air stream at frozen part
and wave back and forth until part
is defrosted or thawed.
Loosening Nuts and Bolts
Direct hot air stream at nut or bolt
to be loosened for a short period of
time. Heating the nut or bolt will
cause the metal to expand.
Remove the air stream from work
piece. Loosen nut or bolt with
proper wrench.
If you have any questions regarding
your specific appli cation or use, feel
free to call our Customer Service
Depart ment at 262-633-7791.
5