Putting Into Operation; Maintenance And Cleaning; Technical Data - EINHELL DSL 250/2 Instructions D'utilisation Et D'entretien

Anleitung_DSL_250_2_SPK1:_
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.

4. Technical data

Permissible working pressure max.:
Idle speed: 22,000 min
Air consumption:
Recommended hose diameter:
Sound pressure level LPA: 88.7 dB (A)
Sound power level LWA: 99.7 dB (A)
Vibration a w :
Weight:
Air quality
cleaned and oiled
Air supply
via conditioning unit with filter pressure reducer
and mist oiler
Compressor capacity
approx. 250 l/min. equivalent to a motor rating of 2.2
kW
Work settings
6 bar working pressure set at the pressure
reducer or filter pressure reducer
Please note:
When working with the pin grinder, be sure to
wear the necessary protective clothing. Observe
the safety regulations.
22.01.2009 11:26 Uhr

5. Putting into operation

Screw the supplied plug-in nipple into the air
connection after you have wound 2 to 3 layers of
sealing tape around the thread. Insert adapter sleeve
size Ø 3 mm or Ø 6 mm depending on which
grinding pin you want to use. To do so, unscrew the
lock nut, insert the adapter sleeve and re-tighten the
lock nut by hand. Then insert the correct grinding pin
(make sure it has the correct shaft diameter!) and
tighten the lock nut with the two chuck keys, using
the one key to hold the adapter sleeve mount.

6. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service.
Regular lubrication is vital for the long-term, reliable
6.3 bar
operation of your pin grinder. Use only special tool oil
-1
for this purpose.
You can choose from the following options for
115 l/min
lubricating the tool:
Ø 10 mm
6.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
< 2.5 m/s 2
6.2 By hand
0.65 kg
Each time before you use your impactscrewdriver,
feed 3-5 drops of special tool oil into the air
connection. If the pneumatic tool has not been used
for several days, you must feed 5-10 drops of oil into
the air connection before you switch on. Keep your
pneumatic tool in dry rooms only.
7. The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or
unauthorized tampering.
Seite 9
GB
9