Bunn Sure Immersion 220 Guide D'installation Et D'utilisation page 33

4. Clean the funnel using any mild, non-abrasive,
liquid detergent. Do Not use abrasives to clean
as this can damage the surface of the funnel.
Rinse and Dry.
5. To reinstall the funnel, tip the top edge of the
funnel under the Coffee Chute.
6. Place the Metal Pins on the Flat Springs.
Push down and toward the rear of the machine
to snap the funnel into the funnel arms.
7. Reconnect the Rubber Hose by sliding it over
the funnel inlet fitting. The hose must be fully
engaged on the fitting.
8. Close the front door to resume normal
operation.
CARE AND CLEANING
33
5
6
7