Zodiac AquaLink PDA PS4 Mode D'emploi page 15

Section 4. Using the Equipment On/Off Model Specific Menus
4.1 TEMP1 (Pool or Spa Only)
NOTE
This equipment may not be part of your system. Please check with your installer.
TEMP1 is the priority temperature. It must be set higher than TEMP2, and it overrides TEMP2 whenever it is
enabled. Set temperature for TEMP1 before setting temperature for TEMP2.
4.1.1 To set TEMP1 (Pool or Spa Only)
Highlight EQUIPMENT ON/OFF and press SELECT. Highlight TEMP1 and press SELECT twice. Use the UP/
DOWN arrow keys to set the desired water temperature and press SELECT to make that degree setting take effect.
Return to the main menu by using the BACK button.
4.2 TEMP2 (Pool or Spa Only)
NOTE
This equipment may not be part of your system. Please check with your installer.
TEMP2 is the maintenance (low) temperature. It must be set lower than TEMP1. If TEMP2 is on and TEMP1 is
activated, TEMP2 will turn off and ENABLED will flash. When TEMP1 is turned off again, TEMP2 will reactivate.
4.2.1 To set TEMP2 (Pool or Spa Only)
Highlight EQUIPMENT ON/OFF and press SELECT. Highlight TEMP2 and press SELECT twice. Use the UP/
DOWN arrow keys to set the desired water temperature and press SELECT to make that degree setting take effect.
Return to the main menu by using the BACK button.
AquaLink PDA | Installation and Operation Manual
®
EQUIPMENT
FILTER PUMP ON
TEMP 1 OFF
TEMP 2 OFF
SOLAR HEAT OFF
POOL LIGHT OFF
AUX 2 OFF
AUX 3 OFF
AUX 4 OFF
MORE
TEMP1
must be set
higher than
Use ARROW KEYS
TEMP2 to set value.
press ANY key Press SELECT
to continue.
to continue.
ENGLISH
TEMP2 EQUIPMENT
FILTER PUMP
ENABLED
TEMP 1
TEMP 2
SET TO 60°F
SOLAR HEAT
POOL LIGHT
AUX 2
AUX 3
AUX 4
Page 15
ON
OFF
ON
OFF
OFF
OFF
OFF
OFF
MORE