Auxiliary Equipment - Zodiac AquaLink PDA PS4 Mode D'emploi

Page 12
ENGLISH

3.7 Auxiliary Equipment

The AUX modes control each of the auxiliary devices plus an extra AUX. To assign a different name to an auxiliary
device, use the SYSTEM SETUP and LABEL AUX menus.
NOTE
Auxiliary devices are items or equipment such as pool and spa lights, waterfalls, or air blowers.
3.7.1 To turn an Auxiliary on or off
Highlight EQUIPMENT ON/OFF and press SELECT. Highlight an AUX and press SELECT. Use the SELECT button
to turn the equipment on or off.
3.8 Heat Pump
NOTE
This equipment may not be part of your system. Please check with your installer. The label HEAT PUMP may take up to
24 hours to appear on the screen after initial heat pump installation.
The HEAT PUMP selection controls the heat pump operation. In order to use the heat pump, the filter pump must be
turned on and the heat pump must be in HEAT MODE (See Section 5.10), and the switch on the heat pump on the
equipment pad must also be set to HEAT MODE.
NOTE
HEAT PUMP takes the place of EXTRA AUX or SOLAR HEAT. It is not possible to have any two of these on the
EQUIPMENT ON/OFF menu at the same time.
3.8.1 To use Heat Pump
Highlight EQUIPMENT ON/OFF and press SELECT. Highlight HEAT PUMP and press SELECT. Press the SELECT
button to enable/disable the HEAT PUMP. The HEAT PUMP uses the SET TEMP set point.
AquaLink
®
FILTER PUMP
SPA
ON POOL HEAT
SPA HEAT
OFF
SOLAR HEAT
OFF
AUX 1
OFF
AUX 2
AUX 3
PDA | Installation and Operation Manual
EQUIPMENT
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
MORE
EQUIPMENT
FILTER PUMP ON
SPA OFF
OFF
POOL HEAT
OFF
SPA HEAT
OFF
SOLAR HEAT
ON
AUX 1
OFF
AUX 2
OFF
AUX 3
MORE