Niko 05-353 Mode D'emploi page 66

05-353
- Wiring with analogue control:
- Control circuit and power circuit of the dimmer are galvanically
isolated.
- The control inputs of the dimmer meet the requirements for
safety extra low voltage (SELV). If the control signals originate
from appliances that also meet the SELV requirements, no
specific requirements apply to wire diameter or insulation of
the control wires. You must, however, make sure to keep the
control wiring away from 230V~ lines (min. 10mm). In all other
cases, the SELV guarantee becomes null and void.
- Power graph: power versus ambient temperature.
800
700
600
500
400
300
200
100
0
If the dimmers are mounted alongside each other, they may be
loaded for max. 80%.
After a power cut, the load is switched off.
Up to 30 (non-lit) N.O. contacts (170-00000) can be
connected in parallel. The max. distance is 100m.
66
0 20
temperature (°C)
35 50
EN