Abus IPCB34 Serie Manuel Utilisateur page 131

8.6.7 Scene Change Detection
The function can detect if the camera has been turned.
Sensitivity:
Schedule
To save a schedule, click on "Activate schedule". Specify here on which days of the week and at which times
the alarm output should be active.
The period selection is made by holding down the left mouse button. By clicking on an already marked period,
the details can also be set via keypad or deleted again.
To copy the time selection to other weekdays, move the mouse pointer behind the bar of the weekday already
set and use the "Copy to ..." function.
Apply the settings made by clicking "Save".
Linkage method
Here you can set the action to be performed when an event occurs.
Normal Linkage
Send email:
Notify the surveillance centre:
Uploading to FTP/Memory card/NAS:
The higher the value, the smaller the change in image content must be to trigger an
event.
You receive an email as notification; check the checkbox to activate this.
If an event is triggered, the ABUS CMS software can be
informed. You may then get a picture pop-up, for example.
Check this check box to upload single frames to an FTP server,
the SD card or a connected NAS drive during an event.
132