Grilling With The Rotary Spit; Preparing Roasts; Using The Rotary Spit; Setting The Rotary Spit And Grill - Bosch HGA232150M Notice D'utilisation

within 15 seconds, wait at least one minute. Then repeat the
process to light the burner.

Grilling with the rotary spit

The rotary spit is particularly good for cooking large roasts,
such as rolled roasting joints or poultry. The meat becomes
crispy and brown.

Preparing roasts

To ensure that the roast is well-browned and cooked evenly,
observe the following points:
Skewering and securing the joint to the spit
Position the joint as close as possible to the centre of the rotary
spit.
Use the clamps to secure it at both ends. The rear clamp must
be a minimum of 7 cm from the end of the spit.
You can also truss the joint with string. With poultry, bind the
ends of the wings underneath the back and the thighs against
the body. This prevents them from overbrowning. Pierce the
skin on the underside of the wings to allow the fat to escape.
In the section Tables and tips, you will find a variety of setting
values for grilling with the rotary spit.

Using the rotary spit

Place the support for the rotary spit on the baking tray (fig. A).
1.
Place the rotary spit on the baking tray (fig. B).
2.
Insert the baking tray in position 1 and push it in as far as it
3.
will go. The back panel of the oven has an opening into which
the rotary spit is inserted (fig. C)
Remove the hand grip and close the oven door (fig. D)
4.

Setting the rotary spit and grill

To turn on the rotary spit, follow the instructions below. If you
would like to grill food using the rotary spit, it must be fitted
before you carry out the instructions below.
Open the top cover. The top cover must remain open for as
1.
long as the cooker is in operation.
Turn on the main gas supply to the appliance. Insert the plug
2.
into the socket.
36
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Insert the protecting plate into the groove below the control
3.
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
Close the oven door so that it is as close as possible to the
4.
protecting plate.
Push in the function selector and turn it clockwise to the grill
5.
setting .
(
Keep the function selector pressed in and press the ignition
6.
button at the same time.
8
The gas coming from the gas grill is ignited using the ignition
7.
button. Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up.
The flame failure device is activated. If the gas flame goes
out, the gas supply is automatically shut off by the flame
failure device.
Check whether the flame is lit. If the flame goes out, repeat
8.
the process from step 5.