Setting The Gas Grill; Cleaning The Accessories; Making Settings On The Hob; Advance Cleaning Of Burner Cup And Cap - Bosch HGA232150M Notice D'utilisation

Setting the gas grill

Open the top cover. The top cover must remain open for as
1.
long as the cooker is in operation.
Turn on the main gas supply to the appliance. Insert the plug
2.
into the socket.
Insert the protecting plate into the groove below the control
3.
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
Close the oven door so that it is as close as possible to the
4.
protecting plate.

Making settings on the hob

Your hob is equipped with four gas burners. The following
information explains how to light the gas burners and set the
size of flame.

Advance cleaning of burner cup and cap

Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Replace the burner cup and cap back on the burner shell (4).
Take care not to damage the igniter (3).
The nozzle (5) must be dry and clean. Always position the
burner cap exactly over the burner cup.

Igniting the gas burners

Always position the burner lid on the burner cup correctly. The
openings in the burner cup must remain unobstructed at all
times. All parts must be dry.
Open the top cooker cover. The top cover must remain open
1.
for as long as the hob is in operation.
Turn the hotplate control for the required hotplate anti-
2.
clockwise to the symbol with the large flame
Push in the function selector and turn it clockwise to the grill
5.
setting
Keep the function selector pressed in and press the ignition
6.
button
The gas coming from the gas grill is ignited using the ignition
7.
button. Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up.
Check whether the flame is lit. If the flame goes out, repeat
8.
the process from step 5.
Switch off the function selector after 30 minutes. Once the
9.
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.

Cleaning the accessories

Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
With the hotplate control pressed in, press the ignition button.
3.
Gas will begin to flow out and the gas burner will ignite.
Set the required flame size. Between the Off position
4.
the
choose a position between the large flame
flame
Check whether the flame is lit.If it is not, repeat the procedure
5.
from step 2.
To finish cooking, turn the hotplate control clockwise to the
6.
Off position
The hotplate control should not be actuated for longer than 15
seconds in the ignition position.If the burner does not ignite
within 15 seconds, wait at least 1 minute before repeating the
procedure.
The gas burner does not ignite
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.
— .
.
(
at the same time.
8
position, the flame is not stable. Therefore, always
—
.
˜
û .
and
û
and the small
—
33