Parkside PMFW 310 D2 Traduction Des Instructions D'origine page 11

Scraper Z52 A1
Materials
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
– removal of material residues, such as tile
adhesive, when replacing damaged tiles
Changing tools
NOTE
► If you plan to use the dust collection unit, it
must be connected before fitting or changing
the tool (see section "Connecting a dust
extraction device") .
WARNING! RISK OF INJURY!
■ Always remove the plug from the power
socket before working on the power tool .
■ Check that the tool is fitted firmly . Incorrectly or
insecurely fitted tools can come loose during
use and cause you an injury .
■ If necessary, remove an already fitted tool .
To do this, raise the tool release lever
■ 8 │ GB │ IE
■ Fit the tool (e .g . the plunge saw blade
the tool holder .
NOTE
► You can fit the tools in any snap position on
the tool holder .
■ Lock the tool into place by pushing the tool
release lever
Fitting the sanding sheet onto
the sanding plate
Attaching
♦ Sanding sheets
pad
fastening .
NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding pad
► Note that the holes for dust extraction from
sanding sheet
aligned .
♦ Position the sanding sheet
of the sanding pad
sheet on the sanding plate .
Operation
Switching on and off
Switching on
♦ Push the ON/OFF switch
the appliance on .
.
Switching off
♦ Push the ON/OFF switch
switch the appliance off .
back down again .
are attached to the sanding
by means of the hook and pile
and sanding pad
flush on one side
, then place the sanding
forwards to switch
backwards to
PMFW 310 D2
) onto
, remove
.
are