Tripp-Lite SmartOnline SUINT1000XLCD Manuel D'utilisation page 7

3. Operation Panel
3.1 LED Indicators
GREEN LED: Indicates the output status.
1. ON (green): Output available
2. OFF: Output unavailable
RED LED:
1. ON: The UPS detects an internal fault or an environmental fault. Refer to 3.3 LCD
Readout for more information.
2. Flashing: The UPS has the following warning message(s):
a.
b.
3.2 Multi-Function Buttons
ON: The button has four functions. Refer to the following for detailed information:
1. Turn-on:
• In standby mode, press and hold the button for 3 seconds. Release it after one
beep. The UPS will run in on-line mode.
• Cold start: When there is no AC input, press and hold the button for 3 seconds.
Release it after one beep. The UPS will start up in battery mode.
2. Battery Test: A battery test may only be executed in on-line mode.
• From manual battery test, press and hold the button for 3 seconds. Release it after
one beep. The UPS will transfer to battery mode and perform a 10-second battery
test.
If the test result is normal, the LCD will show 'PAS' and the UPS will return to on-
line mode.
If the test result is abnormal, the LCD will show 'bAd', the
warning icon
UPS will return to on-line mode.
18-09-252-93358B.indb 7
: There is no battery or battery replacement is needed.
: The UPS is overloaded.
and no-battery/ battery replacement icon
3.1 LED Indicators
3.3 LCD Readout
(including 3.4 7-Segment Display)
3.2 Multi-function Buttons
7
LED will flash, the
will illuminate. The
1/9/2019 2:19:27 PM