Tripp-Lite SmartOnline SUINT1000XLCD Manuel D'utilisation page 11

3. Operation Panel
LOAD
1. LOAD & %: When the two illuminate together, it indicates how much of the UPS system's total
capacity is being used.
2. LOAD & KVA: When the two illuminate together, it indicates the total load in kVA.
3. LOAD & KW: When the two illuminate together, it indicates the total load in kW.
4. LOAD & % & : When (LOAD), unit (%) and
icon flash together, it indicates the UPS has an
overload situation.
V
Indicates voltage.
%
Indicates percentage.
Hz
Indicates frequency.
kVA
Indicates kVA.
kW
Indicates kW.
MIN
Indicates minute.
°C
Indicates the UPS system's internal temperature.
3.5 Flow Chart of the 7-Segment Display
The following flow chart shows how to go through each display screen. Below, Standby Mode is
used as an example. (Each of the display diagrams shown below is for reference only. Actual display
depends on the UPS operation.)
After this screen appears for approximately 10 seconds, the scrolling function will be active. The
scrolling button is .
11
18-09-252-93358B.indb 11 1/9/2019 2:19:28 PM