Dolmar EM-41 Manuel D'instructions D'origine page 10

Before using, check the supply and extension cords for
signs of damaged during use, disconnect the cord for
signs of damage or aging. If the cord becomes damaged
during use, disconnect the cord from the supply
immediately. DO NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY. Do not use the
appliance if the cord is damaged or worn. Keep extension
cord away from cutting elements.
12. MAINTENANCE AND CARE
WARNING: Before performing any Maintenance
or cleaning work, always pull out the mains plug!
Do not spray the unit with water. Ingress of water may
destroy the switch-plug combination unit and the electric
motor. Clean the unit with a cloth, hand brush, etc.
Expert inspection is required, do not make any
adjustment by yourself, must contact to Dolmar
authorized service centre:
a) If the lawn mower strikes an object.
b) If the motor stops suddenly.
c) If the blade is bent (do not align!).
d) If the motor shaft is bent (do not align!).
e) If a short-circuit occurs when the cable is connected.
f) If the gears are damaged.
g) If the V-belt is defective.
13. TROUBLE SHOOTING
WARNING: Before performing any maintenance
or cleaning work, always pull out the mains plug and wait
until the cutter has come to a standstill.
Fault Remedial action
Check mains connection cable.
Start on short grass or on an area which
Motor does not has already been mown.
run Clean discharge channel/housing-the
mowing blade must rotate freely.
Correct the cutting height.
Correct the cutting height.
Clean discharge channel/housing.
Motor power
Have mowing blade resharpened/
drops
replaced →
authorized service centre.
Correct the cutting height.
Allow the lawn to dry.
Have mowing blade resharpened/
Grass catcher
replaced →
is not filled
authorized service centre.
Clean the grille on the grass catcher.
Clean the discharge channel/housing.
CAUTION: Faults which cannot be rectified with
the aid of this table may be rectified by Dolmar authorized
service centre only.
10
14. ENVIRONMENTALLY
FRIENDLY DISPOSAL
According to EU directive 2002/96/EC on
electric and electronic equipment and its
implementation into national law, all electric
tools must be separately collected and
environmentally friendly recycled.
Alternative disposal: If the owner of the power
tool does not return the tool to the manufacturer, he is
responsible for proper disposal at a designated collection
point that prepares the device for recycling according to
national recycling laws and regulations.
This does not include accessories and tools without
electric or electronic components.
For European countries only
EC Declaration of Conformity
The undersigned, Tamiro Kishima and Rainer
Bergfeld, as authorized by Dolmar GmbH, declare that
the DOLMAR machine(s):
Designation of Machine: Electric Lawn Mower
Model No./ Type: EM-41
Specifications: See "4. Technical Data"
are of series production and
Conforms to the following European Directives:
2006/42/EC, 2006/95/EC, 2004/108/EC, 2000/14/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60335, EN62233, EN55014, EN61000
The technical documentation is on file at:
Dolmar GmbH,
Jenfelder Straße 38, Abteilung FZ,
D-22045 Hamburg
The conformity assessment procedure required by
Directive 2000/14/EC was in Accordance with annex VI.
Notified Body:
TÜV SÜD Industrie Service GmbH
Westendstraße 199, D-80686 München
Identification number: 0036
Model EM-41
Measured Sound Power Level:91.4 dB
Guaranteed Sound Power Level: 96 dB
25th November 2009
Tamiro Kishima
Managing Director
Rainer Bergfeld
Managing Director