Troubleshooting - Atlantic TATOU DIGITAL Notice D'utilisation Et D'installation

P
ROBLEM
ENCOUNTERED
The heating light flas- The temperature probe is disconnected or is faulty.
hes Contact your installer.
The device does not Make sure that the
heat. If you are operating under programming, check that the programmer is in
COMFORT mode. Ensure that the installation's circuit breakers are engaged and
that the power cut-off (if you have one) has not cut off the power to the device.
Check the air temperature in the room: if it is too high, the heating light does
not flash : the device does not heat.
The device heats all - Check that the device is not in a draught or that the temperature setting has
the time.
- There may be a fluctuation in the main power supply. If there is a problem
- If the phenomenon recurs frequently, have your electricity utility check the
The device heats There may be a delay between when the window is opened and when the
even though the win- heating stops.
dow is open. If you find this delay too long, you can manually stop your device.
The device does not Increase the temperature settings by pressing the + (E) key.
heat enough. If the setting is at its maximum, carry out the following checks:
- Check whether there is another heating device in the room.
- Make sure that your device is only heating the room (door closed).
- Check the supply voltage to the device.
- Check that the power of your device is adapted to the size of your room
The heating light This is normal. The device can heat to maintain an Eco temperature.
appears on the
screen when the
device is in Eco
mode.
Dirty marks appear The dirty marks come from the bad quality of the air in the room. In this case,
on the wall around you are advised to check that the room is correctly aired (ventilation, vent duct,
the device. etc.), that the air is clean and not to smoke in the room. Your device will not
be replaced under guarantee because of these dirty marks.
T
ROUBLESHOOTING
not been altered.
(blocked thermostat...), cut off the power to the device (fuse, circuit breaker)
for approximately 10 minutes and then switch it back on.
power supply.
(on average, we recommend 100 W/m² for a ceiling height of 2.50 m).
C
HECKS TO BE MADE
mode is activated.
47
GB