Troubleshooting - Atlantic SOKIO Notice D'utilisation

Problem encoun-
tered
The control unit
screen does not
come on .
The ambient
temperature differs
from that displayed
on the appliance .
The appliance does
not heat up .
The appliance heats
up
continuously .
The appliance does
not heat up suffi-
ciently .
The surface of the
appliance is very hot .

Troubleshooting

Checks to make
Check that the switch located behind the appliance is in the I posi-
tion .
Check the power supply to the appliance .
A period of at least six hours needs to elapse for the temperature
to stabilise .
It is possible, depending on your installation, that you will record a
temperature that differs from that displayed on the appliance (a differ-
ence of 0.5°C is normal) . In this case, refer to the "Expert mode menu"
"T° Calibration" chapter .
If you have chosen programming, check that you are within a Com-
fort time window . Check that the installation's circuit-breakers are
set or that the cut-off device (if present) has not interrupted the
operation of the appliance . Check the air temperature in the room:
if it is too high compared to the setpoint temperature, the appliance
will not heat up .
Check that the appliance is not located in a draught (door open nearby,
air escaping through the cable cover behind the appliance) or that the
temperature setting has not been changed .
There may be a problem in the electrical network . In the event of a
problem (thermostat blocked, etc.), cut the power supply to the appli-
ance (fuse, circuit-breaker) for approximately 10 minutes, then turn the
appliance back on .
If the phenomenon repeatedly occurs, check the power supply with
your power distributor .
Increase the temperature by pressing
temperature" chapter) .
If the setting is at the maximum, perform the following checks:
- Check whether there is another form of heating in the room .
- Ensure that your appliance only heats up the room (door closed) .
- Check the power supply voltage for the appliance .
- Check whether the power of your appliance is suitable for the
size of your room (we recommend an average of 100 W/m
height of 2.50 m or 40W/m
It is normal for the appliance to be hot when it operates, the maxi-
mum surface temperature is limited in accordance with the NF Elec-
tricity standard . However, if you feel that your appliance is always
too hot, check that the power is suitable for the surface area of your
room (we recommend an average of 100 W/m
2.50 m or 40W/m
3
that could interfere with its temperature regulation .
) .
3
) and that the appliance is not placed in a draught
36
(refer to the "Adjusting the
for a ceiling
2
for a ceiling height of
2