Midea MRT18S2AWW Manuel D'utilisation page 15

4.
In order to remove the plug, you
need to squeeze the two ends
and pull the plug out, or need to
use the tools such as a flat screw
driver or needle nose plier.
5.
Carefully Remove the plugs /
label from inside the freezer
compartment using a putty knife.
6.
Peel away the label covering the
ice-maker installation hole.
7.
Using a pair of needle nose pliers,
remove the foam from the hole.
8.
Insert the water inlet tube into
the small hole on the back of
the refrigerator. Rotate the hose
while inserting until the flat
surface of the hose is secure
against the back of the
refrigerator.
Label
Discard Foam
Plug
15