Ice Maker Installation Instructions (Optional) - Midea MRT18S2AWW Manuel D'utilisation

10.
Put down the freezer door on the middle hinge vertically, then take out
the top hinge and cover of other side from accessory bag, assemble
top hinge, hinge cover and hole cover.
(The picture above is only for reference. The actual configuration will
depend on the physical product.)
ICE MAKER INSTALLATION INSTRUCTIONS
(OPTIONAL)
The refrigerator is ready for ice maker installation, if you need ice maker,
optional icemaker kit model # IM1800MD is available from your retailer.
Tools Required:
•
1/4"
copper supply line with shut off valve
•
1/4"
brass compression nut and ferrule
•
Minimum/Maximum inlet water pressure, 138/827 kPa (20/120 PSIG).
Connect to potable water supply only.
The copper tubing and shut off valve are available in a kit from your
local hardware or plumbing supply store. Coil enough tubing at the
back of the unit to allow movement for cleaning.
WARNING
Unplug the refrigerator. To eliminate the danger of electric shock during
installation, you must unplug the refrigerator from its electrical outlet.
Top hinge
Hole cover
13