CST/BERGER LASERMARK Wizard LM30 Manuel D'instructions page 6

NOTE: The more accurately the vial bubbles are centered, the more accurate
the laser beam will be for referencing level.
3. Turn power on and press the control button once for "FAST" speed
(ideal for use outdoors with a laser detector), or twice for "SLOW"
speed (ideal for indoor use). You have created a highly visible, level ref-
erence line (Fig. 3).
Plumbing
1. On a flat surface, place the instrument on its back using the built-in triv-
et (control button facing upward).
2. Level the instrument by viewing the plumb vial and turning the front lev-
eling screw until the plumb vial bubble is centered (Fig. 4).
3. Turn power on and press the control button until you reach your desired
speed. You have created a highly visible, plumb reference line!
Stopping the Rotary Head
It is possible to stop rotation of the head in order to manually direct the laser
dot towards a target, much like a straight-line laser.
1. Turn the unit on by pressing the control button.
2. Press two more times until the "STOP" LED is lit. The rotary head will
stop turning.
3. Align the laser beam to your target by turning the rotary head manually.
Sweep Modes (Point & Shoot Scanning)
The LM30's Sweep Modes create an easily visible laser "chalk line" that you
can direct by manually turning the rotary head.
This is especially useful on job sites where you must contain the laser's loca-
tion to avoid interference with other laser users or laser detectors on site.
Also, this feature is very useful for extending the range of the visible beam.
You may use this feature in either a level or plumb position.
6 • LM30 Rotary Laser